Infiniti QX: Driving on snow or ice
WARNING
► Wet ice (328F, 08C and freezing rain),
very cold snow or ice can be slick and
very hard to drive on. The vehicle will
have much less traction or “grip” under
these conditions. Try to avoid driving on
wet ice until the road is salted or
sanded.
► Whatever the condition, drive with caution.
Accelerate and slow down with
care. If accelerating or downshifting too
fast, the drive wheels will lose even
more traction.
► Allow more stopping distance under
these conditions. Braking should be
started sooner than on dry pavement.
► Allow greater following distances on
slippery roads.
► Watch for slippery spots (glare ice).
These may appear on an otherwise clear
road in shaded areas. If a patch of ice is
seen ahead, brake before reaching it. Try
not to brake while on the ice, and avoid
any sudden steering maneuvers.
► Do not use the cruise control on slippery
roads.
► Snow can trap dangerous exhaust gases
under your vehicle. Keep snow clear of
the exhaust pipe and from around your
vehicle.
Special winter equipment
It is recommended that the following items
be carried in the vehicle during winter:
► A scraper and stiff-bristled brush to
remove ice and snow from the windows
and wiper blades.
υ ...
Engine block heater (if so equipped)
Engine block heaters are used to assist in
cold temperature starting.
The engine block heater should be used
when the outside temperature is 208F
(−78C) or lower.
To use the engine bloc ...
See also:
Seat belts
Display messages
After starting the
engine, the red seat
belt warning lamp lights
up for six seconds.
Possible causes/consequences and ►
Solutions
The seat belt warning lamp reminds the ...
Starter Switch Check
WARNING
When you are doing this inspection, the vehicle could move suddenly. If the vehicle
moves, you or others could be injured.
1. Before starting this check, be sure there is enough room ar ...
Tire Sealant
Read and follow the safe handling instructions on the label adhered to the sealant
canister.
Check the tire sealant expiration date on the sealant canister. The sealant canister
should be replaced ...






