Cadillac Escalade: Setting the Clock
The navigation system time and the analog clock operate independently. Changing the time through the navigation system does not change the time on the analog clock. See Clock to change the analog clock time.
Press CONFIG to enter the configure menu options, then press CONFIG repeatedly until the time is selected or press the time screen button.
Hours: Press − or + to decrease or increase the hours.
Minutes: Press − or + to decrease or increase the minutes.
12/24 Format: Select the 12 screen button for standard time; select the 24 screen button for military time.
Rear Display
Press the Rear Display(s) screen button to allow the choice of sources for rear
display between front disc, rear aux, or usb, if connected. ...
Global Positioning System (GPS)
The navigation system determines the position of the vehicle by using satellite
signals, various vehicle signals, and map data.
At times, other interferences such as the satellite condition, road co ...
See also:
Meter/ring illumination and needle sweep
The ring illumination surrounding meters
and gauges illuminates when the driver’s
door is closed after getting into the vehicle
with the Intelligent Key carried in.
When the engine is starte ...
SBZA Detection Zones
The SBZA sensor covers a zone of approximately one lane over from both sides
of the vehicle, 3.5m (11 ft). This zone starts at each side mirror and goes back
approximately 5.0m(16 ft). The height ...
Center multi-function control panel
1. “CAMERA” Around View Monitor display
button (P.4-21) 2, 6, 7.For navigation system control buttons
(Refer to the separate Navigation
System Owner’s Manual.)
3. INFINITI controller ( ...
