Cadillac Escalade: Global Positioning System (GPS)
The navigation system determines the position of the vehicle by using satellite signals, various vehicle signals, and map data.
At times, other interferences such as the satellite condition, road configuration, the condition of the vehicle and/or other circumstances can interfere with the navigation system's ability to determine the accurate position of the vehicle.
The GPS shows the current position of the vehicle using signals sent by the GPS Satellites of the United States Department of Defense. When the vehicle is not receiving signals from the satellites, a symbol appears on the map screen. Refer to Global Positioning System (GPS) .
This system may not be available or interferences may occur if any of the following are true:
- Signals are obstructed by tall buildings, trees, large trucks, or a tunnel.
- Objects are located on the front dash of the vehicle.
- Satellites are being repaired or improved.
- After-market glass tinting has been applied to the vehicle's windshield.
Notice: Do not apply after-market glass tinting to the vehicle's windows. Glass tinting interferes with the system's ability to receive GPS signals and causes the system to malfunction. The window might have to be replaced to correct the problem. This would not be covered by the warranty.
For more information if the GPS is not functioning properly, see Vehicle Positioning and Problems with Route Guidance .
Setting the Clock
The navigation system time and the analog clock operate independently. Changing
the time through the navigation system does not change the time on the analog clock.
See Clock to change t ...
Vehicle Positioning
At times, the position of the vehicle on the map may be inaccurate due to one
or more of the following reasons:
Road system has changed.
Vehicle is driving on slippery road surfaces such as in ...
See also:
Rear media control from the touch screen
When the main rear media control screen is displayed on the touch screen, the
rear media remote control will be locked out. No part of the rear media system will
operate until it is turned on via ...
Switching on Blind Spot Assist
► Make sure that the radar sensor system and Blind Spot Assist are activated in the on-board
computer.
► Turn the SmartKey to position 2 in the
ignition lock.
Warning lamps 1 light u ...
Erasing Speed Memory
The cruise control set speed is erased from memory by pressing the
button or if the ignition is turned
off. ...






