Buick Enclave: License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate trim.
2. Turn and pull the license plate lamp forward through the liftgate trim opening.
3. Turn the bulb socket counterclockwise and pull the bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the license plate lamp.
Taillamps, Turn Signal, Sidemarker, and Stoplamps
A. Taillamp
B. Sidemarker Lamp
To replace one of these bulbs:
1. Open the liftgate. See Liftgate .
2. Remove the black cuff from the lamp assembly by pulling rearward from the top
to unfasten ...
Replacement Bulbs
For replacement bulbs not listed here, contact your dealer. ...
See also:
Dialing a number from the phone book
You can enter new telephone numbers into
the phone book via the mobile phone (see the
separate operating instructions). If your
mobile phone is operational, you can select
and dial a number from t ...
Checking Engine Oil
It is a good idea to check the engine oil level at each fuel fill. In order to
get an accurate reading, the vehicle must be on level ground. The engine oil dipstick
handle is a yellow loop. See Engi ...
Hood
To open the hood:
1. Pull the handle with this symbol on it. It is located inside the vehicle to
the lower left of the steering wheel.
2. Then go to the front of the vehicle and locate the seco ...
