Buick Enclave: License Plate Lamp - Bulb Replacement - Vehicle Care - Buick Enclave Owner's ManualBuick Enclave: License Plate Lamp

To replace one of these bulbs:

1. Remove the two screws holding each of the license plate lamps to the liftgate trim.

2. Turn and pull the license plate lamp forward through the liftgate trim opening.

2. Turn and pull the license plate lamp forward through the liftgate trim opening.
3. Turn the bulb socket counterclockwise and pull the bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the license plate lamp.

    Taillamps, Turn Signal, Sidemarker, and Stoplamps
    A. Taillamp B. Sidemarker Lamp To replace one of these bulbs: 1. Open the liftgate. See Liftgate . 2. Remove the black cuff from the lamp assembly by pulling rearward from the top to unfasten ...

    Replacement Bulbs
    For replacement bulbs not listed here, contact your dealer. ...

    See also:

    Checking the tire pressures
    Important safety notes WARNING   Follow recommended tire inflation pressures. Do not underinflate tires. Underinflated tires wear excessively and/or unevenly, adversely affect handling ...

    Rear window wiper blades
    Contact an INFINITI retailer if checking or replacement is required. ...

    Adding Washer Fluid
    The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID L ...