Infiniti QX: INFINITI all-mode 4WD® (if so equipped)
WARNING
► Do not attempt to raise two wheels off
the ground and shift the transmission to
any drive or reverse position with the
engine running. Doing so may result in
drivetrain damage or unexpected vehicle
movement which could result in serious
vehicle damage or personal injury.
► Do not attempt to test a 4WD equipped
vehicle on a 2-wheel dynamometer or
similar equipment even if the other two
wheels are raised off the ground. Make
sure you inform test facility personnel
that your vehicle is equipped with 4WD
before it is placed on a dynamometer.
Using the wrong test equipment may
result in drivetrain damage or unexpected
vehicle movement which could
result in serious vehicle damage or
personal injury.
CAUTION
► Do not drive the vehicle in the 4HI or 4LO
position on dry hard surface roads.
Driving on dry, hard surfaces in 4HI or
4LO may cause unnecessary noise, tire
wear and increased fuel consumption.
If the Four-Wheel Drive (4WD) warning
light turns on when driving on dry hard
surface roads:
— in the 4HI position, shift the 4WD
shift switch to AUTO.
— in the 4LO position, stop the vehicle
and shift the transmission lever to
the N (Neutral) position with the
brake pedal depressed and shift the
4WD shift switch to AUTO.
If the 4WD warning light is still on
after the above operation, have your
vehicle checked by an INFINITI retailer
as soon as possible.
► The transfer case may be damaged if you
continue driving with the 4WD warning
light blinking.
See “On-pavement and off-road driving
precautions” earlier in this section for
other precautions for offroad driving.
Increasing fuel economy
► Accelerate slowly and smoothly. Maintain
cruising speeds with a constant
accelerator position.
► Drive at moderate speeds on the highway.
► Avoid unnecessary stopping and b ...
INFINITI all-mode 4WD® system
The all mode 4WD system provides 3
positions (AUTO, 4HI and 4LO), so you
can select the desired drive mode according
to the driving conditions.
4WD shift procedure:
1: The 4LO and 4HI indic ...
See also:
Using RSE
The system is operated using the remote control.
To release the remote from the docked position, press at the top of the remote
to unlatch it.
NOTICE
Do not attempt to pull the remote contro ...
Restricted seat travel
NOTICE
If seat movement stops unexpectedly during adjustment, check for and remove any
obstructions.
Once any obstructions have been removed, the seat adjustment mechanism can be
reset as f ...
Auto closure
If the lift gate is pulled down to a partly
open position, the lift gate will pull itself to
the closed position.
Do not apply excessive force when the
auto closure is operating. Excessive for ...
