Buick Enclave: Headlamp High/ Low-Beam Changer
Headlamp High/Low-Beam Changer:
Push the turn signal/lane change lever away from you to turn the high beams on.
Pull the lever toward you to return to low beams.
This indicator light turns on in the instrument panel cluster when the high-beam headlamps are on.
Exterior Lamp Controls
The exterior lamps control is located on the instrument panel to the left of
the steering wheel.
It controls the following systems:
► Headlamps
► Taillamps
► Parking Lamps
& ...
Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass.
If the headlamps are off or in the low-beam position, pull the turn signal lever
toward you to momentarily switch to high ...
See also:
Reprograming a single garage door opener button
To program a device to a previously programed button:
1. Press and hold the desired pre-programed garage door opener button for at
least 20 seconds, but no longer than 30 seconds, until the indicat ...
Snow chains
For safety reasons, Mercedes-Benz
recommends that you only use snow chains
which have been specially approved for your
vehicle by Mercedes-Benz, or are of a
corresponding standard of quality.
...
Attaching the front towing eye
The front towing point is located behind a removable cover in the lower front
bumper.
1. Rotate each of the fasteners 90 degrees counter-clockwise with a coin (or
similar).
2. To remove the co ...
