Cadillac Escalade: Tow/Haul Mode
Pressing this button at the end of the shift lever turns on and off the tow/haul mode.
This indicator light on the instrument panel cluster comes on when the tow/haul mode is on.
Tow/Haul is a feature that assists when pulling a heavy trailer or a large or heavy load. See Tow/Haul Mode for more information.
Tow/Haul is designed to be most effective when the vehicle and trailer combined weight is at least 75 percent of the vehicle's Gross Combined Weight Rating (GCWR). See “Weight of the Trailer” in Trailer Towing . Tow/Haul is most useful under the following driving conditions:
- When pulling a heavy trailer or a large or heavy load through rolling terrain.
- When pulling a heavy trailer or a large or heavy load in stop and go traffic.
- When pulling a heavy trailer or a large or heavy load in busy parking lots where improved low speed control of the vehicle is desired.
Operating the vehicle in Tow/Haul when lightly loaded or with no trailer at all will not cause damage. However, there is no benefit to the selection of Tow/Haul when the vehicle is unloaded. Such a selection when unloaded may result in unpleasant engine and transmission driving characteristics and reduced fuel economy. Tow/ Haul is recommended only when pulling a heavy trailer or a large or heavy load.
Electric Brake Control Wiring Provisions
These wiring provisions are included with the vehicle as part of the trailer
wiring package. These provisions are for an electric brake controller. The instrument
panel contains blunt cut wires near ...
Trailer Sway Control (TSC)
Non-hybrid vehicles with StabiliTrak have a Trailer Sway Control (TSC) feature.
If the vehicle is towing a trailer and the system detects that the trailer is swaying,
the vehicle brakes are applied ...
See also:
Telescopic rod
The telescopic rod can be used to secure the
load against the rear seats to prevent it from
moving around.
► Insert one mounting element 2 into each
loading rail.
► Turn mounting el ...
How to use INFINITI controller
Choose an item on the display by rotating
or pushing the center dial 1 upward/
downward, and push the ENTER button 2
for operation.
If you push the BACK button3 before the
setup is complet ...
Important safety notes
You will find an illustration of the instrument
cluster in the "At a glance" section.
WARNING
A driver's attention to the road and traffic
conditions must always be his/her p ...