Cadillac Escalade: Electric Brake Control Wiring Provisions
These wiring provisions are included with the vehicle as part of the trailer wiring package. These provisions are for an electric brake controller. The instrument panel contains blunt cut wires near the data link connector for the trailer brake controller. The harness contains the following wires:
- Dark Blue: Brake Signal to Trailer Connector
- Red/Black: Battery
- Light Blue/White: Brake Switch
- White: Ground
It should be installed by your dealer or a qualified service center.
Trailer Wiring Harness
Heavy-Duty Trailer Wiring Harness Package
The vehicle has a seven-pin universal heavy-duty trailer connector attached to
the rear bumper beam next to the integrated trailer hitch.
The seven-wire ...
Tow/Haul Mode
Pressing this button at the end of the shift lever turns on and off the tow/haul
mode.
This indicator light on the instrument panel cluster comes on when the tow/haul
mode is on.
Tow/Haul is a ...
See also:
Address Book
The address book entry method lets you select a destination by selecting an address
that has been stored in the address book.
Address Book: Press to access the
Address Book screen. From this scr ...
Lamp check
A bulb check is initiated for some warning lamps when the ignition is switched
on and lasts for 3 seconds (except for the air bag warning lamp which remains illuminated
until the engine is started ...
Total Weight on the Vehicle's Tires
Be sure the vehicle's tires are inflated to the inflation pressures found on
the Certification label on the driver door or see Vehicle Load Limits
for more information. Make sure not ...
