Cadillac Escalade: Park Brake and P (Park) Mechanism Check - Vehicle Checks - Vehicle Care - Cadillac Escalade Owner's ManualCadillac Escalade: Park Brake and P (Park) Mechanism Check

Cadillac Escalade / Cadillac Escalade Owner's Manual / Vehicle Care / Vehicle Checks / Park Brake and P (Park) Mechanism Check

WARNING WARNING

When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.

Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.

  • To check the parking brake's holding ability: With the engine running and the transmission in N (Neutral), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only.
  • To check the P (Park) mechanism's holding ability: With the engine running, shift to P (Park). Then release the parking brake followed by the regular brake.

Contact your dealer if service is required.

    Ignition Transmission Lock Check
    While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position. The ignition should turn to LOCK/OFF only when the shift lever is in P (Park). ...

    Wiper Blade Replacement
    Windshield wiper blades should be inspected for wear or cracking. See Maintenance Schedule  . Replacement blades come in different types and are removed in different ways. ...

    See also:

    115 V power socket
    WARNING   The 115V AC socket operates at high voltage. Use the 115V AC socket in the vehicle with the same caution and prudence that you exercise when using power outlets at home. Keep ...

    Traction – AA, A, B, C
    The traction grades, from highest to lowest, are AA, A, B, and C. Those grades represent the tire's ability to stop on wet pavement as measured under controlled conditions on specified governmen ...

    Lighting control
    1. Headlamps/side lamps off. 2. Side lamps on. 3. Low beam headlamps on. 4. Autolamps on: With the switch in this position and the ignition on, the side lamps, low beam headlamps and license pl ...