Range Rover: To erase all programing
For first time programing, ensure that the engine is switched off:
1. Ensure that the ignition is on (but with the engine switched off).
2. Press and hold the two outer buttons on the transceiver in the rear-view mirror. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 seconds), then release the buttons.
All memories in the garage door opener have now been cleared.
Note: Do not perform this procedure when programing the additional garage door opener buttons.
Programing
With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the end of the original garage door opener hand-held transmitter 2 to 6 inches (50 to 150 mm) away from the transc ...Rolling code device equipment programing
Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage ...See also:
3-D Lane Guidance
Some major metropolitan areas may include a 3-D lane guidance feature for highway
exits and junctions. This feature gives you an enhanced representation of the exits
and junctions on the route. ...
Displaying the coolant temperature
WARNING
Driving when your engine is overheated can
cause some fluids which may have leaked into the engine compartment to catch
fire. You could be seriously burned.
Steam from an over ...
Engine Cover
A. Oil Fill Cap
B. Engine Cover
To remove:
1. Remove the oil fill cap (A).
2. Raise the engine cover (B) to release it from the retainers.
3. Lift and remove the engine cover.
4. Reverse Steps ...