Range Rover: Switching off the engine - Starting the engine - Range Rover Owner's ManualRange Rover: Switching off the engine

Before stopping the engine, ensure that the vehicle is parked safely with the parking brake applied and P selected.

Press and release the engine START/STOP button to stop the engine. The audio, telephone and touch screen systems will revert to stand-by mode.

Pressing the START/STOP button again (without pressing the brake pedal), will activate the systems.

Switching off the engine while the vehicle is moving:

NOTICE NOTICE

It is not advisable to switch off the engine while the vehicle is moving. However, if a situation arises where engine switch off is urgent, the following procedure applies:

1. Press and hold the START/STOP button for 2 seconds, or

2. Press and release the START/STOP button twice within 2 seconds.

With either method, the warning message Engine Stop Button Pressed will be displayed.

    If the engine fails to start
    If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t ...

    Rolling re-start
    A rolling restart can be initiated by selecting N (neutral) and pressing the engine START/STOP button. ...

    See also:

    Ultrasonic Parking Assist
    If available, the Ultrasonic Rear Parking Assist (URPA) system uses sensors on the rear bumper to assist with parking and avoiding objects while in R (Reverse). WARNING The URPA system does not ...

    If your vehicle is stolen
    If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufact ...

    Securing the vehicle to prevent it fromrolling away
    WARNING   Only jack up the vehicle on level ground or on slight inclines/declines. The vehicle could otherwise fall off the jack and injure you or others. If your vehicle is equipped wi ...