Cadillac Escalade: Setting the Clock
The navigation system time and the analog clock operate independently. Changing the time through the navigation system does not change the time on the analog clock. See Clock to change the analog clock time.
To set the time for the navigation system:
1. Press CONFIG to enter the configure menu options, then press CONFIG again, repeatedly until the time is selected or touch the time screen button.
2. Press the Hours and Minutes − and + to decrease or to increase the time.
See “Setting the Clock” under Configure Menu for more information.
Storing Radio Station Presets
To set preset radio stations, do the following:
1. Press to turn the system on.
2. Press AUDIO and select the desired band (AM, FM, or XM (if equipped)).
3. Use the (tuning) knob,
, or
(Seek) ...
Entering an Address and Point of Interest, and Storing Preset Destinations
Entering an Address
Enter a destination by inputting the city name first:
1. Press O to turn the system on.
2. A caution may appear. Press OK to proceed.
3. Press DEST.
4. Press2(Address Entry).
...
See also:
Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the
washer fluid is low. The message is displayed for 15 seconds at the start of each
ignition cycle. When the WASHER FLUID L ...
Rear Climate Control System (Rear Climate with Rear Seat Audio)
For vehicles with the rear heat and air conditioning controls, they are integrated
with the rear seat audio controls located in the center console. The system can
be controlled from the front contro ...
Lashing points
A. Front lashing points.
B. Rear lashing points.
WARNING
The front and rear lashing points must be used only securing the vehicle during
transportation. If they are used for any other purp ...
