Range Rover: Resuming the speed and follow mode
NOTICE
RESUME should only be used if the driver is aware of the set speed and intends to return to it.
By pressing the RESUME button after ACC has been cancelled (e.g. after braking), the ACC will become active again provided that the set speed memory has not been erased. The original set speed will be resumed (unless a vehicle ahead causes the follow mode to become active) and the set speed will be displayed in the message center for 4 seconds.
ACC auto OFF
ACC will disengage, but not clear the memory when: • The CANCEL button is pressed. • The brake pedal is pressed. • Neutral (N) is selected. • Dynamic Stability Control (DSC) activate ...Hints on driving with ACC
The system acts by regulating the speed of the vehicle, using engine control and the brakes. Gear changes may occur in response to deceleration or acceleration while in ACC. ACC is not a collisio ...See also:
Vehicle Security
This vehicle has theft-deterrent features; however, they do not make it impossible
to steal. ...
Ultrasonic Parking Assist
If available, the Ultrasonic Rear Parking Assist (URPA) system uses sensors on
the rear bumper to assist with parking and avoiding objects while in R (Reverse).
WARNING
The URPA system does not ...
Lockout Protection
If the driver side power door lock switch is pressed when the driver door is
open and the key is in the ignition, all of the doors will lock and then the driver
door will unlock.
If the passenger s ...