Cadillac Escalade: Replacing Brake System Parts
The braking system on a vehicle is complex. Its many parts have to be of top quality and work well together if the vehicle is to have really good braking. The vehicle was designed and tested with top-quality brake parts. When parts of the braking system are replaced, be sure to get new, approved replacement parts. If this is not done, the brakes might not work properly. For example, installing disc brake pads that are wrong for the vehicle, can change the balance between the front and rear brakes — for the worse. The braking performance expected can change in many other ways if the wrong replacement brake parts are installed.
Brake Adjustment
Every time the brakes are applied, with or without the vehicle moving, the brakes
adjust for wear. ...
Brake Fluid
The brake master cylinder reservoir is filled with DOT 3 brake fluid. See Engine
Compartment Overview for the location of the reservoir.
There are only two reasons why the brake fluid ...
See also:
General maintenance
During the normal day-to-day operation of
the vehicle, general maintenance should
be performed regularly as prescribed in
this section. If you detect any unusual
sounds, vibrations or smell, b ...
Wheel changing
1. Read and observe the warnings in Wheel changing safety.
2. Before raising the vehicle, use the wheel nut brace to slacken the wheel nuts
half a turn counter-clockwise.
3. Position the jack unde ...
Rolling code device equipment programing
Note: The assistance of a second person, may make the following steps quicker
and easier. Once the button has been pressed there are only 30 seconds in which
to complete Step 3.
1. At the garage ...
