Cadillac Escalade: Brake Fluid
The brake master cylinder reservoir is filled with DOT 3 brake fluid. See Engine Compartment Overview for the location of the reservoir.
There are only two reasons why the brake fluid level in the reservoir might go down:
- The brake fluid level goes down because of normal brake lining wear. When new linings are installed, the fluid level goes back up.
- A fluid leak in the brake hydraulic system can also cause a low fluid level. Have the brake hydraulic system fixed, since a leak means that sooner or later the brakes will not work well.
Do not top off the brake fluid. Adding fluid does not correct a leak. If fluid is added when the linings are worn, there will be too much fluid when new brake linings are installed. Add or remove brake fluid, as necessary, only when work is done on the brake hydraulic system.
WARNING
If too much brake fluid is added, it can spill on the engine and burn, if the engine is hot enough. You or others could be burned, and the vehicle could be damaged. Add brake fluid only when work is done on the brake hydraulic system. See “Checking Brake Fluid” in this section.
When the brake fluid falls to a low level, the brake warning light comes on. See Brake System Warning Light .
Refer to the Maintenance Schedule to determine when to check the brake fluid. See Maintenance Schedule .
Replacing Brake System Parts
The braking system on a vehicle is complex. Its many parts have to be of top quality and work well together if the vehicle is to have really good braking. The vehicle was designed and tested with to ...Checking Brake Fluid
Check brake fluid by looking at the brake fluid reservoir. See Engine Compartment Overview . The fluid level should be above MIN. If it is not, have the brake hydraulic system checked to se ...See also:
Rear Climate Control System (Rear Climate Control Only)
A. Fan Control
B. Temperature Control
C. Air Delivery Mode Control
For vehicles with the rear climate control system, the controls are located on
the rear of the center console. The system can ...
Sand
This program should be used for terrain which is predominantly soft dry sand
or deep gravel.
Note: If the vehicle is unable to gain traction in extremely soft, dry sand,
switching DSC off may h ...
Cleaning genuine wood and trimelements
► Wipe the wooden trim and trim pieces
with
a damp, lint-free cloth, e.g. a microfiber
cloth.
► Heavy soiling: use car care and cleaning
products recommended and approved by
Mercede ...