Cadillac Escalade: Rear Wiper Blade Replacement - Wiper Blade Replacement - Vehicle Checks - Vehicle Care - Cadillac Escalade Owner's ManualCadillac Escalade: Rear Wiper Blade Replacement

1. Lift the wiper blade assembly up and out of the park rest position.

2. Pull the wiper blade assembly away from the backglass. The backglass wiper

2. Pull the wiper blade assembly away from the backglass. The backglass wiper blade will not lock in a vertical position, so care should be used when pulling it away from the vehicle.

3. Turn the wiper blade assembly, and pull it off of the wiper arm. Hold the wiper arm in position and push the blade away from the wiper arm.

4. Replace the wiper blade.

4. Replace the wiper blade.

5. Return the wiper blade assembly to the park rest position.

    Front Wiper Blade Replacement
    1. Pull the windshield wiper arm connector away from the windshield. 2. Squeeze the grooved areas on each side of the blade, and turn the blade assembly away from the arm connector. 3. Install ...

    Glass Replacement
    If the windshield or front side glass must be replaced, see your dealer to determine the correct replacement glass. ...

    See also:

    Passenger Sensing System
    The passenger sensing system, if equipped, turns off the front outboard passenger frontal airbag under certain conditions. No other airbag is affected by the passenger sensing system. If the vehicl ...

    Fuel System Messages
    FUEL LEVEL LOW This message displays and a chime sounds if the fuel level is low. Refuel as soon as possible. See Fuel Gauge  and Fuel  for more information. TIGHTEN GAS CAP This messa ...

    Overheated Engine Protection Operating Mode
    If an overheated engine condition exists and the ENGINE POWER IS REDUCED message is displayed, an overheat protection mode which alternates firing groups of cylinders helps prevent engine damage. In ...