Infiniti QX: Rear-facing child restraint installation using LATCH - Child restraints - Safety — seats, seat belts and supplemental restraint system - Infiniti QX Owner's ManualInfiniti QX: Rear-facing child restraint installation using LATCH

Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint in the 2nd row seats using the LATCH system: 1. Position the child restraint on the seat. Always follow the child restraint manufacturer’s instructions.


Rear-facing web-mounted — step 2

2. Secure the child restraint anchor attachments to the LATCH lower anchors. Check to make sure the LATCH attachment is properly attached to the lower anchors.


Rear-facing rigid-mounted — step 2


Rear-facing — step 3

3. For child restraints that are equipped with webbing-mounted attachments, remove any additional slack from the anchor attachments. Press downward and rearward firmly in the center of the child restraint with your hand to compress the vehicle seat cushion and seatback while tightening the webbing of the anchor attachments.


Rear-facing — step 4

4. After attaching the child restraint, test it before you place the child in it. Push it from side to side while holding the child restraint near the LATCH attachment path. The child restraint should not move more than 1 inch (25 mm), from side to side. Try to tug it forward and check to see if the LATCH attachment holds the restraint in place. If the restraint is not secure, tighten the LATCH attachment as necessary, or put the restraint in another seat and test it again. You may need to try a different child restraint or try installing by using the vehicle seat belt (if applicable). Not all child restraints fit in all types of vehicles. 5. Check to make sure the child restraint is properly secured prior to each use. If the child restraint is loose, repeat steps 1 through 4.

    Top tether strap child restraint
    If the manufacturer of your child restraint requires the use of a top tether strap, it must be secured to an anchor point. WARNING ► In the 3rd row bench seat, a child restraint with a ...

    Rear-facing child restraint installation using the seat belts
    WARNING ► The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restr ...

    See also:

    Position of the steering wheel fordriving
    The steering wheel is moved to the last selected position when: • the driver's door is closed. • you insert the SmartKey into the ignition lock. or • you press the Start/Stop button once o ...

    Uniform tire quality grading
    Quality grades can be found where applicable on the tire sidewall between the tread shoulder and maximum section width. For example: Treadwear 200 Traction AA Temperature A. In addition to the mar ...

    Ultrasonic Parking Assist
    If available, the Ultrasonic Rear Parking Assist (URPA) system assists the driver with parking and avoiding objects while in R (Reverse). URPA operates at speeds less than 8 km/h (5 mph). The sen ...