Cadillac Escalade: Lumbar Adjustment - Seat Adjustment - Initial Drive Information - In Brief - Cadillac Escalade Owner's ManualCadillac Escalade: Lumbar Adjustment

To adjust the lumbar support:

To adjust the lumbar support:

  • Press and hold the front or rear of the control to increase or decrease lumbar support.
  • Press and hold the top or bottom of the control to raise or lower the height of the support.

See Lumbar Adjustment  .

    Seat Adjustment
    To adjust the seat: Move the seat forward or rearward by sliding the control forward or rearward. Raise or lower the front or rear part of the seat cushion by moving the front or rear of the ...

    Reclining Seatbacks
    To adjust the seatback: Tilt the top of the control rearward to recline. Tilt the top of the control forward to raise. See Reclining Seatbacks  . ...

    See also:

    Removing the Spare Tire and Tools
    The equipment needed to change a flat tire is stored under the storage tray, located on the driver side trim panel, over the rear wheelhouse. Regular Wheelbase Shown, Extended Wheelbase Similar. ...

    Vehicle defects (Canada)
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform Transport Canada, in addition to notifying Jaguar Land Rover C ...

    Air cleaner
    To remove the filter, release the lock pins 1 and pull the unit upward 2 . The filter element should not be cleaned and reused. Replace it according to the maintenance intervals. See “INFI ...