Cadillac Escalade: How the System Works - Ultrasonic Parking Assist - Object Detection Systems - Driving and Operating - Cadillac Escalade Owner's ManualCadillac Escalade: How the System Works

URPA comes on automatically when the shift lever is moved into R (Reverse). A single tone sounds to indicate the system is working.

URPA operates only at speeds less than 8 km/h (5 mph).

An obstacle is indicated by audible beeps. The interval between the beeps becomes shorter as the vehicle gets closer to the obstacle. A continuous tone is heard when the distance is less than 30 cm (12 in).

To be detected, objects must be at least 25 cm (10 in) off the ground and below liftgate level. Objects must also be within 2.5 m (8 ft) from the rear bumper. This distance may be less during warmer or humid weather.

    Ultrasonic Parking Assist
    If available, the Ultrasonic Rear Parking Assist (URPA) system uses sensors on the rear bumper to assist with parking and avoiding objects while in R (Reverse). WARNING The URPA system does not ...

    Turning the System On and Off
    Press this button, located next to the radio, to disable URPA. The indicator light will come on and PARK ASSIST OFF displays on the Driver Information Center (DIC). See Object Detection System Mes ...

    See also:

    Rear Side Window Antenna
    The AM-FM antenna is located in the passenger rear side windows. Make sure the inside surfaces of the rear side windows are not scratched and that the lines on the glass are not damaged. If the insi ...

    Window reset
    The windows will need to be reset if the battery is disconnected, becomes discharged or power supply is interrupted. Reset as follows: 1. Close the window fully. 2. Release the switch, then lift ...

    Remote Keyless Entry (RKE) System
    The RKE transmitter is used to remotely lock and unlock the doors from up to 60 m (195 ft) away from the vehicle. Press to unlock the driver door. Press again within five seconds to unlock a ...