Buick Enclave: Hood
To open the hood:

1. Pull the hood release handle with this symbol on it. It is located under the instrument panel on the driver side of the vehicle.

2. At the front of the vehicle, pull up on the bottom center of the grille, and
push the secondary hood release to the left.
3. After the lid has been partially lifted, a gas strut automatically lifts and
holds the hood in the fully open position.
Before closing the hood, be sure all filler caps are on properly.
Pull the hood down to close.
Lower the hood until the lifting pressure of the strut is reduced.
Then allow the hood to fall and latch into place under its own weight.
Check to make sure the hood is closed. If the hood does not fully latch, gently push the hood down at the front and center until it is completely latched.
Doing Your Own Service Work
WARNING
You can be injured and the vehicle could be damaged if you try to do service
work on a vehicle without knowing enough about it.
► Be sure you have sufficient knowledge, experience, t ...
Engine Compartment Overview
A. Radiator Pressure Cap. See Cooling System .
B. Engine Coolant Recovery Cap. See Cooling System .
C. Remote Negative (−) Terminal.
See Jump Starting .
D. Engine Compartment Fuse Block .
...
See also:
Tire pressure of at least 180 kPa(1.8 bar/26 psi) is not reached
If, after five minutes, a pressure of 180 kPa
(1.8 bar/26 psi) has not been achieved:
► Press the on/off switch on the tire
inflation
compressor to 0.
The tire inflation compressor is ...
Filling the Tank
WARNING
Fuel vapor burns violently and a fuel fire can cause bad injuries.
To help avoid injuries to you and others, read and follow all the instructions
on the fuel pump island. Turn off the engi ...
Useful information
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences are ...






