Buick Enclave: Windshield Wiper/Washer
The windshield wiper/washer lever is located on the left side of the steering column.
Turn the band with the wiper symbol to control the windshield wipers.
(Mist): Use for a single wiping
cycle.
(Off): Use to turn the wipers off.
Delays wiping cycle. Turn the band up for more frequent wipes or down for less frequent wipes.
► : Slow wipes.2 : Fast wipes.
Clear ice and snow from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged wiper blades should be replaced. See Wiper Blade Replacement .
Heavy snow or ice can overload the wipers. A circuit breaker stops them until the motor cools.
Windshield Washer
(Washer Fluid): Press the button
at the end of the turn signal/lane change lever, to spray washer fluid on the windshield.
The wipers clear the windshield and either stop or return to the preset speed. The ignition key must be in ACC/ACCESSORY or ON/RUN for this to work. See Washer Fluid .
WARNING
In freezing weather, do not use the washer until the windshield is warmed. Otherwise
the washer fluid can form ice on the windshield, blocking your vision.
WASHER FLUID LOW ADD FLUID is displayed on the Driver Information Center (DIC) when the washer fluid is low. See Washer Fluid Messages .
Steering Wheel Controls
Vehicles with audio steering wheel controls could differ depending on the vehicle's
options. Some audio controls can be adjusted at the steering wheel.
(Next/Previous):
Press to select pres ...
Rear Window Wiper/Washer
The rear wiper and rear wash button is located on the instrument panel below
the climate control system.
(Rear Wiper): Press to turn the
rear wiper on and off. The wiper speed cannot be changed. ...
See also:
Making adjustments in 1 mph (Canada:1 km/h) increments
► Briefly press the cruise control lever
to the
pressure point, up 1 for a higher speed or
down 2 for a lower speed.
The last speed stored is increased or
reduced. ...
Stationary range changing
With the vehicle stationary, select N.
Move the transfer gearbox switch towards the range required and release. The
switch returns to the default position and range change status will be confirmed ...
Switching DSC ON
DSC is re-enabled by one of the following:
• Press and briefly hold the DSC OFF switch.
• Start the engine.
• Select a new Terrain response special program.
...