Mercedes-Benz GL-Class: Centrally locking and unlocking thevehicle from the inside - Doors - Opening/closing - Mercedes-Benz GL-Class Owner's ManualMercedes-Benz GL-Class: Centrally locking and unlocking thevehicle from the inside

You can centrally lock or unlock the vehicle from the inside.

The central locking/unlocking button does not lock or unlock the fuel filler flap.

The buttons are located on both front doors.

from the inside if the vehicle has been You cannot unlock the vehicle centrally from the inside if the vehicle has been locked with the SmartKey or KEYLESS-GO.

centrally if the front-passenger door is It is only possible to lock the vehicle centrally if the front-passenger door is closed.

► To unlock: press button 1.

To unlock: press button 1.
To lock: press button 2.

If all the doors and the tailgate are closed, the vehicle locks.

You can open a front door from inside the vehicle even if it has been locked. Only open the door when the traffic situation permits.

If the vehicle has been locked with the central locking button:

and the SmartKey is set to its factory setting, the entire vehicle is unlocked if a front door is opened from the inside
and the SmartKey is set to an individual setting, only the front door that is opened from inside the vehicle is unlocked.

If the vehicle has been locked centrally with the SmartKey or with KEYLESS-GO, it is not unlocked when the release button for the central locking is used.

    Unlocking and opening doors fromthe inside
    You can open a door from inside the vehicle even if it has been locked. You can only open the rear doors from inside the vehicle if they are not secured by the child-proof locks. Only open the d ...

    Automatic locking feature
    The vehicle locks automatically when the ignition is switched on and the wheels of the vehicle are turning at a speed of more than 9 mph (15 km/h). You could therefore be locked out when: • ...

    See also:

    Important safety notes
    WARNING   When operating the climate control, the air that enters the passenger compartment through the air vents can be very hot or very cold (depending on the set temperature). This c ...

    Imperial/metric/mixed display
    The trip computer readings can be changed between metric, imperial and mixed units in the Trip Computer menu of the message center. See 55, INTERACTIVE CONTROLS. Note: Temperature display can be ch ...

    Rolling code device equipment programing
    Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage ...