Infiniti QX: Windshield wiper and washer switch
WARNING
In freezing temperatures the washer solution
may freeze on the window and obscure
your vision which may lead to an accident.
Warm the window with the defroster before
you wash the window.
CAUTION
► Do not operate the washer continuously
for more than 30 seconds.
► Do not operate the washer if the
reservoir tank is empty.
► Do not fill the window washer reservoir
tank with washer fluid concentrates at
full strength. Some methyl alcohol
based washer fluid concentrates may
permanently stain the grille if spilled
while filling the window washer reservoir
tank.
► Pre-mix washer fluid concentrates with
water to the manufacturer’s recommended
levels before pouring the fluid
into the window washer reservoir tank.
Do not use the window washer reservoir
tank to mix the washer fluid concentrate
and water.
If the windshield wiper operation is interrupted by snow or ice, the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to the OFF position and remove the snow or ice that is on and around the wiper arms. In approximately 1 minute, turn the switch on again to operate the wiper.

The windshield wiper and washer operates
when the ignition switch is in the ON
position.
Push the lever down to operate the wiper
at the following speed:
1 AUTO — operates the rain-sensing
auto wiper system. (See “Rain-sensing
auto wiper system” later in this
section.)
2 LO — continuous low speed operation
3 HI — continuous high speed operation
4 MIST — one sweep operation of the
wiper
INFINITI Vehicle Immobilizer System
The INFINITI Vehicle Immobilizer System
will not allow the engine to start without
the use of the registered Intelligent Key.
Never leave these keys in the vehicle.
This device complies with P ...
Washer operation
To operate the washer, pull the lever
toward the back of the vehicle 5 until
the desired amount of washer fluid is
spread on the windshield. The wiper will
automatically operate several times. ...
See also:
Daytime running lamps
Daytime running lamps in Canada
The "daytime running lamps" function is
required by law in Canada. It cannot therefore
be deactivated.
► Turn the light switch to
.
With the e ...
Battery Replacement
To change the remote control batteries:
1. Slide the rear cover back on the remote control.
2. Replace the two batteries in the compartment. Make sure they are installed
correctly using the diagram ...
How to Check Lubricant
To get an accurate reading, the vehicle should be on a level surface.
A. Drain Plug
B. Fill Plug
If the level is below the bottom of the fill plug hole, located on the transfer
case, some lubric ...






