Infiniti QX: INFINITI Vehicle Immobilizer System
The INFINITI Vehicle Immobilizer System will not allow the engine to start without the use of the registered Intelligent Key. Never leave these keys in the vehicle. This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.
Security indicator light
The security indicator light is located on the meter panel. It indicates the status of the INFINITI Vehicle Immobilizer System. The light blinks after the ignition switch was in the ACC, OFF and LOCK position. This function indicates the security systems equipped on the vehicle are operational. If the INFINITI Vehicle Immobilizer System is malfunctioning, this light will remain on while the ignition switch is in the ON position. If the light still remains on and/or the engine will not start, see an INFINITI retailer for INFINITI Vehicle Immobilizer System service as soon as possible. Please bring all Intelligent Keys that you have when visiting an INFINITI retailer for service.
Vehicle Security System
The vehicle security system provides visual
and audio alarm signals if someone opens
the doors, hood, or lift gate when the
system is armed. It is not, however, a
motion detection type system ...
Windshield wiper and washer switch
WARNING
In freezing temperatures the washer solution
may freeze on the window and obscure
your vision which may lead to an accident.
Warm the window with the defroster before
you wash the w ...
See also:
Battery care
WARNING
If swallowed, battery fluid can be fatal, seek medical assistance immediately.
Do not allow battery fluid to contact your skin or eyes. It is both toxic and
corrosive which can result ...
Adjusting the multicontour seat
You can adjust the contour of the front seats
individually so as to provide optimum support
for your back and sides.
► Make sure that the SmartKey is in
position
2 in the ignition lock.
...
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate
trim.
2. Turn and pull the license plate lamp forward through the liftgate trim op ...