Mercedes-Benz GL-Class: Tire pressure of at least 180 kPa(1.8 bar/26 psi) is not reached - TIREFIT kit - Flat tire - Breakdown assistance - Mercedes-Benz GL-Class Owner's ManualMercedes-Benz GL-Class: Tire pressure of at least 180 kPa(1.8 bar/26 psi) is not reached

If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved:

Press the on/off switch on the tire inflation compressor to 0.

The tire inflation compressor is switched off.

Unscrew the filler hose from the valve of the faulty tire.
Very slowly drive forwards or reverse approximately 30 ft (10 m).
Pump up the tire again.

WARNING If after five minutes a pressure of 180 kPa 
If after five minutes a pressure of 180 kPa (1.8 bar/26 psi) cannot be achieved, the tire is too badly damaged to be repaired reliably using TIREFIT.
In this case TIREFIT cannot seal the tire properly.
Do not drive any further.
Contact the nearest authorized Mercedes-Benz Center for assistance or call Roadside Assistance.

    TIREFIT kit version 2
    ► Pull connector 4 with the cable and hose 5 out of the housing. ► Screw hose 5 onto flange 6 of tire sealant bottle 1. ► Insert tire sealant bottle 1 head downwards into re ...

    Tire pressure of 180 kPa (1.8 bar/26 psi) is reached
    ► Press the on/off switch on the tire inflation compressor to 0. The tire inflation compressor is switched off. ► Unscrew the filler hose from the valve of the faulty tire. ...

    See also:

    Important
    The information contained in this handbook covers all vehicle derivatives and optional equipment, some of which may not be fitted to your vehicle. Due to printing cycles, this handbook may include ...

    Security
    OnStar provides services like Stolen Vehicle Assistance, Remote Ignition Block, and Roadside Assistance, if the vehicle is equipped with these services. OnStar can unlock the vehicle doors remotely, ...

    Key and Lock Messages
    REPLACE BATTERY IN REMOTE KEY This message displays if a Remote Keyless Entry (RKE) transmitter battery is low. The battery needs to be replaced in the transmitter. See “Battery Replacement” un ...