Buick Enclave: Vehicle Messages
Messages are displayed on the DIC to notify the driver that the status of the vehicle has changed and that some action may be needed by the driver to correct the condition.
Multiple messages may appear one after another.
Some messages may not require immediate action, but you can press any of the DIC buttons on the instrument panel to acknowledge that you received the messages and to clear them from the display.
Some messages cannot be cleared from the DIC display because they are more urgent. These messages require action before they can be cleared. You should take any messages that appear on the display seriously and remember that clearing the messages will only make the messages disappear, not correct the problem.
The following are the possible messages that can be displayed and some information about them.
Driver Information Center (DIC)
Your vehicle has a Driver Information Center (DIC).
The DIC displays information about your vehicle. It also displays warning messages
if a system problem is detected.
All messages will appear in ...
Battery Voltage and Charging Messages
BATTERY SAVER ACTIVE
This message displays when the system detects that the battery voltage is dropping
below expected levels. The battery saver system starts reducing certain features
of the veh ...
See also:
Lumbar Adjustment
To adjust the lumbar support:
Press and hold the front or rear of the control to increase or decrease
lumbar support.
Press and hold the top or bottom of the control to raise or lower the
...
Vehicle Dynamic Control (VDC) OFF switch
The vehicle should be driven with the
Vehicle Dynamic Control (VDC) system on
for most driving conditions.
If the vehicle is stuck in mud or snow, the
VDC system reduces the engine output to ...
Safety Locks
The vehicle has rear door security locks to prevent passengers from opening the
rear doors from the inside.
Open the rear doors to access the security locks on the inside edge of each door.
To s ...
