Cadillac Escalade: Setting Cruise Control - Cruise Control - Cruise Control - Driving and Operating - Cadillac Escalade Owner's ManualCadillac Escalade: Setting Cruise Control

If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used.

The cruise control light on the instrument panel cluster comes on after the cruise control has been set to the desired speed.

1. Press the 2. Get up to the desired speed. button.
2. Get up to the desired speed.
3. Press the SET− button located on the steering wheel and release it.
4. Take your foot off the accelerator.

    Cruise Control
    WARNING Cruise control can be dangerous where you cannot drive safely at a steady speed. So, do not use the cruise control on winding roads or in heavy traffic. Cruise control can be dangerous ...

    Resuming a Set Speed
    If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory. Once the vehicle speed reaches about 40 k ...

    See also:

    Tachometer
    The tachometer indicates engine speed in revolutions per minute (RPM). Do not rev the engine into the red zone 1 . CAUTION When engine speed approaches the red zone, shift to a higher gea ...

    Off-road recovery
    If the right side or left side wheels unintentionally leave the road surface, maintain control of the vehicle by following the procedure below. Please note that this procedure is only a genera ...

    Replacement sensor
    Should the sensor require replacing, it should be carried out by a Land Rover Retailer/ Authorized Repairer. A replacement sensor must be fitted to a running wheel in order to be recognized by th ...