Cadillac Escalade: Resuming a Set Speed - Cruise Control - Cruise Control - Driving and Operating - Cadillac Escalade Owner's ManualCadillac Escalade: Resuming a Set Speed

If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory.

Once the vehicle speed reaches about 40 km/h (25 mph) or more, press the +RES button on the steering wheel. The vehicle returns to the previous set speed and stays there.

    Setting Cruise Control
    If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used. The cruise control light on the ...

    Increasing Speed While Using Cruise Control
    If the cruise control system is already activated, . Press and hold the +RES button on the steering wheel until the desired speed is reached, then release it. . To increase vehicle speed in small a ...

    See also:

    Using ACC
    1. SET+: Press to increase or set the speed. 2. Press to resume the set speed. 3. Press to decrease the set speed. 4. CAN: Cancels, but retains the set speed in memory. 5. Press to decrease the ...

    General notes
    USA only: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device mus ...

    Electric Brake Control Wiring Provisions
    These wiring provisions are included with the vehicle as part of the trailer wiring package. These provisions are for an electric brake controller. The instrument panel contains blunt cut wires near ...