Buick Enclave: Ride Control System Messages - Information Displays - Instruments and Controls - Buick Enclave Owner's ManualBuick Enclave: Ride Control System Messages

SERVICE STABILITRAK

This message displays if there is a problem with the StabiliTrak® system. If this message appears, try to reset the system. Stop; turn off the engine for at least 15 seconds; then start the engine again. If this message still comes on, it means there is a problem. See your dealer for service. The vehicle is safe to drive, however, you do not have the benefit of StabiliTrak, so reduce your speed and drive accordingly.

SERVICE TRACTION CONTROL

This message displays when there is a problem with the Traction Control System (TCS). When this message is displayed, the system will not limit wheel spin. Adjust your driving accordingly. See your dealer for service. See StabiliTrak® System  for more information.

TRACTION CONTROL OFF

This message displays when the Traction Control System (TCS) is turned off. Adjust your driving accordingly. See StabiliTrak® System  for more information. This message clears itself after 10 seconds.

TRACTION CONTROL ON

This message displays when the Traction Control System (TCS) is turned on. See StabiliTrak® System  for more information.

This message clears itself after 10 seconds.

    Object Detection System Messages
    PARK ASST (Assist) BLOCKED SEE OWNERS MANUAL This message displays if there is something interfering with the park assist system. See Ultrasonic Parking Assist  for more information. PARK ASS ...

    Airbag System Messages
    SERVICE AIR BAG This message displays if there is a problem with the airbag system. Have your dealer inspect the system for problems. See Airbag Readiness Light  and Airbag System  for m ...

    See also:

    Changing engine coolant
    Major cooling system repairs should be performed by an INFINITI retailer. The service procedures can be found in the appropriate INFINITI Service Manual. Improper servicing can result in reduc ...

    Tool kit
    Note: Tool types and positions may vary from the illustrations. The tool kit is located under a panel set in the loadspace floor. Note: Take careful note of the stowage position for each tool, as ...

    Transfer
    You may not transfer the DATABASE to third parties, except together with system for which it was created, provided that you do not retain any copy of the DATABASE, and provided that the transferee ...