Range Rover: Reprograming a single garage door opener button - Garage door opener - Range Rover Owner's ManualRange Rover: Reprograming a single garage door opener button

To program a device to a previously programed button:

1. Press and hold the desired pre-programed garage door opener button for at least 20 seconds, but no longer than 30 seconds, until the indicator lamp begins to flash.

2. Without releasing the rear-view mirror button, position the hand-held transmitter approximately 2 to 6 inches (50 to 150 mm) away from the transceiver in the rear-view mirror, keeping the indicator lamp in view.

3. Carry out Step 3 of Programing.

    Rolling code device equipment programing
    Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage ...

    Entry gate/canadian programing
    The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programing. Continue to press and hold the desired rear-view ...

    See also:

    Trailer direction indicators (green)
    Illuminates as a bulb check when the ignition is switched on and extinguishes when the engine is started. If a trailer is attached, the warning lamp will flash in conjunction with the direction ...

    Fuels in Foreign Countries
    Never use leaded gasoline or any other fuel not recommended in the previous text on fuel. Costly repairs caused by use of improper fuel would not be covered by the vehicle warranty. To check the fu ...

    TIREFIT kit version 1
    ► Open flap 2. ► Pull connector 5 with the cable and hose 6 out of the housing. ► Screw hose 6 onto flange 7 of tire sealant bottle 1. ► Insert tire sealant bottle : hea ...