Range Rover: Entry gate/canadian programing - Garage door opener - Range Rover Owner's ManualRange Rover: Entry gate/canadian programing

Range Rover / Range Rover Owner's Manual / Garage door opener / Entry gate/canadian programing

The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programing.

Continue to press and hold the desired rear-view mirror button while you cycle your hand-held transmitter until the indicator lamp flashes rapidly.

    Reprograming a single garage door opener button
    To program a device to a previously programed button: 1. Press and hold the desired pre-programed garage door opener button for at least 20 seconds, but no longer than 30 seconds, until the indicat ...

    Information and assistance
    NOTICE It is recommended that when you sell or dispose of the vehicle, the programed transceiver buttons be erased for security purposes. For information on the range of available compatible ...

    See also:

    Interior Care
    To prevent dirt particle abrasions, regularly clean the vehicle's interior. Immediately remove any soils. Note that newspapers or dark garments that can transfer color to home furnishings can a ...

    Controls (front touch screen)
    WARNING Do not adjust the touch screen controls, or allow the system to distract the driver, while the vehicle is moving. Driver distraction can lead to accidents, causing serious injury o ...

    Battery Load Management
    The vehicle has Electric Power Management (EPM) that estimates the battery's temperature and state of charge. It then adjusts the voltage for best performance and extended life of the battery. ...