Buick Enclave: Remote Vehicle Start
This vehicle may have a remote starting feature that starts the engine from outside of the vehicle.
(Remote Start): This button is located on the RKE transmitter if the vehicle has remote start.
Laws in some communities may restrict the use of remote starters.
For example, some laws may require a person using the remote start to have the vehicle in view when doing so. Check local regulations for any requirements on remote starting of vehicles.
Do not use the remote start feature if the vehicle is low on fuel.
The vehicle could run out of fuel.
If the vehicle has the remote start feature, the RKE transmitter functions have an increased range of operation. However, the range may be less while the vehicle is running.
There are other conditions that can affect the performance of the transmitter. See Remote Keyless Entry (RKE) System for additional information.
Starting the Engine Using Remote Start
To start the vehicle:
1. Aim the RKE transmitter at the vehicle.
2. Press and release on the RKE transmitter.
3. Immediately after completing Step 2, press and hold
until the parking lamps flash. If the
vehicle's lights cannot be seen, press and hold
for at least four seconds.
When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running.
The doors will be locked and the climate control system will operate automatically if the vehicle has the automatic system, or at the same setting as when the vehicle was last turned off.
If the vehicle has an automatic climate control system and heated seats, the heated seats turn on during colder outside temperatures and shut off when the key is turned to ON/RUN. See Heated and Ventilated Front Seats for more information.
The rear window defogger and heated mirrors, if the vehicle has them, turn on during colder outside temperatures and turn off when the key is turned to ON/RUN.
After entering the vehicle during a remote start, insert and turn the key to the ON/RUN position to drive the vehicle.
If the vehicle is left running it automatically shuts off after 10 minutes unless a time extension has been done.
Extending Engine Run Time
To extend the engine run time by 10 minutes, repeat Steps 1 through 3 while the engine is still running. The engine run time can only be extended if it is the first remote start since the vehicle has been driven. Remote start can be extended one time.
If the remote start procedure is used again before the first 10-minute time frame has ended, the first 10 minutes will immediately expire and the second 10-minute time frame will start.
For example, if and then are pressed again after the vehicle has been running for five minutes, 10 minutes are added, allowing the engine to run for a total of 15 minutes.
► maximum of two remote starts or remote start attempts are allowed between ignition cycles.After the vehicle's engine has been started two times using the remote start button, the ignition must be turned on and then back off before the remote start procedure can be used again
Shutting the Engine Off After a Remote Start
To manually shut off a remote start:
► Aim the RKE transmitter at the vehicle and press until the parking lamps turn off.► Turn on the hazard warning flashers. ► Turn the ignition switch on and then off.
Conditions in Which the Remote Start Will Not Work
The vehicle cannot be started using the remote start feature if the key is in the ignition, the hood is open, or if there is an emission control system malfunction.
The engine turns off during a remote start if the coolant temperature gets too high or if the oil pressure gets low.
Remote Keyless Entry (RKE) System Operation
The Remote Keyless Entry (RKE) transmitter functions work up to 60m (195 ft) away from the vehicle. There are other conditions which can affect the performance of the transmitter. See Remote Keyl ...Door Locks
WARNING Unlocked doors can be dangerous. ► Passengers, especially children, can easily open the doors and fall out of a moving vehicle. When a door is locked, the handle will not open it. Th ...See also:
Vehicles with a "Minispare" emergencyspare wheel
► Lift the trunk floor up.
1 Alignment bolt
2 Towing eye
3 Lug wrench
4 Ratchet wrench
5 Velcro fastener
6 Jack
7 Wheel bolts
8 Folding wheel chock
9 Fuse allocation chart
10 Stowage ...
Removal and Installation of the Sealant Canister
To remove the sealant canister:
1. Unlock the air only hose (F) from the tire sealant canister (B) by pulling
up on the lever.
2. Pull the air only hose (F) from the tire sealant canister (B).
3 ...
Engine protection mode
The engine has an engine protection mode
to reduce the chance of damage if the
coolant temperature becomes too high (for
example, when climbing steep grades in
high temperature with heavy load ...