Range Rover: To erase all programing - Garage door opener - Range Rover Owner's ManualRange Rover: To erase all programing

For first time programing, ensure that the engine is switched off:

1. Ensure that the ignition is on (but with the engine switched off).

2. Press and hold the two outer buttons on the transceiver in the rear-view mirror. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 seconds), then release the buttons.

All memories in the garage door opener have now been cleared.

Note: Do not perform this procedure when programing the additional garage door opener buttons.

    Programing
    With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the end of the original garage door opener hand-held transmitter 2 to 6 inches (50 to 150 mm) away from the transc ...

    Rolling code device equipment programing
    Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage ...

    See also:

    Top tether strap child restraint
    If the manufacturer of your child restraint requires the use of a top tether strap, it must be secured to an anchor point. WARNING ► In the 3rd row bench seat, a child restraint with a ...

    Rocking Your Vehicle to Get It Out
    Turn the steering wheel left and right to clear the area around the front wheels. Turn off any traction or stability system. Shift back and forth between R (Reverse) and a forward gear, spinning the ...

    Underbody
    In areas where road salt is used in winter, the underbody must be cleaned regularly. This will prevent dirt and salt from building up and causing the acceleration of corrosion on the underbody ...