Infiniti QX: Top tether strap child restraint
If the manufacturer of your child restraint requires the use of a top tether strap, it must be secured to an anchor point.
WARNING
► In the 3rd row bench seat, a child
restraint with a top tether strap can only
be used in the center position. Do not
place in an outboard seating position
and attempt to angle the tether strap to
the center position.
► Child restraint anchor points are designed
to withstand only those loads
imposed by correctly fitted child restraints.
Under no circumstances are
they to be used for adult seat belts or
harnesses.
► Do not allow cargo to contact the top
tether strap when it is attached to the
top tether anchor. Properly secure the
cargo so it does not contact the top
tether strap. Cargo that is not properly
secured or cargo that contacts the top
tether strap may damage the top tether
strap during a collision. Your child could
be seriously injured or killed in a
collision if the child restraint top tether
strap is damaged.
Top tether anchor point locations
Anchor points are located in the following
locations:
► 2nd row bench seat (if so equipped) on
the floor behind the outboard seating
positions as shown.
► 2nd row captain’s seats (if so equipped)
on the floor behind the seats as shown.
► 3rd row bench seat on the floor of the
cargo area behind the center seat
position as shown.
If you have any questions when installing
a top tether strap child restraint on the
rear seat, consult an INFINITI retailer for
details.
Installing child restraint LATCH
lower anchor attachments
LATCH webbing-mounted attachment
LATCH compatible child restraints include
two rigid or webbing-mounted attachments
that can be connected to anchors located
at certain seating positions in ...
Rear-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the
“Child safety” and “Child restraints” sections
before installing a child restraint.
Follow these steps to install a rear-facing
child restrain ...
See also:
Headlamp cleaning system
The headlamps are cleaned automatically if
the "Wipe with washer fluid" function is
operated five times while the lights are on and
the engine is running. When you
switch off the ignitio ...
Instrument Panel, Leather, Vinyl, and Other Plastic Surfaces
Use a soft microfiber cloth dampened with water to remove dust and loose dirt.
For a more thorough cleaning, use a soft microfiber cloth dampened with a mild soap
solution.
Notice: Soaking or satur ...
Notes on using dual-zone automaticclimate control
The following contains notes and
recommendations on optimum use of dualzone
automatic climate control.
• Activate climate control using the
and
buttons. The indicator lamps in the
and
b ...