Range Rover: Operating the jack
1. Locate the jack under the recommended jacking point.
2. Attach the cranking lever to the jack using the adaptor. Fit the wheel nut brace to the end of the cranking lever and rotate clockwise to raise the vehicle.
Jacking points
WARNING
The jack is designed for wheel changing only. Never work beneath the vehicle
with the jack as the only means of support. Always use correctly rated vehicle support
stands, before put ...
Wheel changing
1. Read and observe the warnings in Wheel changing safety.
2. Before raising the vehicle, use the wheel nut brace to slacken the wheel nuts
half a turn counter-clockwise.
3. Position the jack unde ...
See also:
Opening and closing the sidewindows
1 Front left
2 Front right
3 Rear right
4 Rear left
The switches for all side windows are located
on the driver's door. There is also a switch on
each door for the corresponding side window.
...
Setting the specified minimum distance
You can set the specified minimum distance
for DISTRONIC by varying the time span
between one and two seconds. This time span
determines the distance that DISTRONIC
should maintain from the vehicl ...
Remote Keyless Entry (RKE) System
The RKE transmitter is used to remotely lock and unlock the doors from up to
60 m (195 ft) away from the vehicle.
Press to unlock the driver door.
Press again within five seconds
to unlock a ...
