Cadillac Escalade: Headlamp High/Low-Beam Changer - Exterior Lighting - Lighting - Cadillac Escalade Owner's ManualCadillac Escalade: Headlamp High/Low-Beam Changer

To change the headlamps from low to high beam, push the lever toward the instrument (Headlamp High/Low Beam Changer): To change the headlamps from low to high beam, push the lever toward the instrument panel. To return to low-beam headlamps, pull the multifunction lever toward you. Then release it.

When the high beams are on, this indicator light on the instrument panel cluster

When the high beams are on, this indicator light on the instrument panel cluster will also be on.

    Exterior Lamps Off Reminder
    If a door is open, a reminder chime sounds when the headlamps or parking lamps are manually turned on and the key is out of the ignition. To turn off the chime, turn the headlamp switch to off or AU ...

    Flash-to-Pass
    Use your high-beam headlamps to signal to a driver in front that you want to pass. It works even if the headlamps are in the automatic position. To use it, pull the turn signal lever toward you, the ...

    See also:

    Turn and Lane-Change Signals
    An arrow on the instrument panel cluster flashes in the direction of the turn or lane change. Move the lever all the way up or down to signal a turn. Raise or lower the lever until the arrow sta ...

    Off-road ABS
    An ABS mode specifically suited to off-road terrain is activated automatically if the offroad drive program is activated or the LOW RANGE off-road gear is selected. At speeds below 18 mph(30 km ...

    How to Check Lubricant
    To get an accurate reading, the vehicle should be on a level surface. A. Fill Plug B. Drain Plug When the differential is cold, add enough lubricant to raise the level from 0mm (0 in) to 3.2 ...