Cadillac Escalade: Flash-to-Pass
Use your high-beam headlamps to signal to a driver in front that you want to pass. It works even if the headlamps are in the automatic position.
To use it, pull the turn signal lever toward you, then release it.
If the headlamps are in the automatic position or on low beam, the high-beam headlamps turn on. They stay on as long as the lever is held. The high-beam indicator on the instrument panel cluster comes on. Release the lever to return to normal operation.
Headlamp High/Low-Beam Changer
(Headlamp High/Low Beam Changer):
To change the headlamps from low to high beam, push the lever toward the instrument
panel. To return to low-beam headlamps, pull the multifunction lever toward you ...
Daytime Running Lamps (DRL)
Daytime Running Lamps (DRL) can make it easier for others to see the front of
your vehicle during the day. Fully functional daytime running lamps are required
on all vehicles first sold in Canada.
...
See also:
Automatic Transmission
If the vehicle is a hybrid, see the hybrid supplement for more information.
The vehicle has a Hydra-Matic® 6L80 automatic transmission, and has an electronic
shift position indicator within the ins ...
Audio/Video (A/V) Jacks
Yellow: Video Input
White: Left Audio Input
Red: Right Audio Input
The A/V jacks, located on the rear of the floor console, allow audio or video
signals to be connected from an auxiliary device ...
Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the
washer fluid is low. The message is displayed for 15 seconds at the start of each
ignition cycle. When the WASHER FLUID L ...






