Cadillac Escalade: Engine Oil Messages - Vehicle Messages - Instruments and Controls - Cadillac Escalade Owner's ManualCadillac Escalade: Engine Oil Messages

CHANGE ENGINE OIL SOON

This message displays when the engine oil needs to be changed. When you change the engine oil, be sure to reset the CHANGE ENGINE OIL SOON message. See Engine Oil Life System   for information on how to reset the message. See Engine Oil   and Maintenance Schedule   for more information.

ENGINE OIL HOT IDLE ENGINE

This message displays when the engine oil becomes hotter than the normal operating temperature. Stop and allow the vehicle to idle until it cools down. See Engine Coolant Temperature Gauge  .

OIL PRESSURE LOW STOP ENGINE

Notice: If you drive the vehicle while the engine oil pressure is low, severe engine damage may occur. If a low oil pressure warning appears on the Driver Information Center (DIC), stop the vehicle as soon as possible. Do not drive the vehicle until the cause of the low oil pressure is corrected. See Engine Oil   for more information.

This message displays if low oil pressure levels occur. Stop the vehicle as soon as safely possible and do not operate it until the cause of the low oil pressure has been corrected. Check the oil as soon as possible and have the vehicle serviced by your dealer. See Engine Oil  .

    Engine Cooling System Messages
    Notice: If you drive the vehicle while the engine is overheating, severe engine damage may occur. If an overheat warning appears on the instrument panel cluster and/or DIC, stop the vehicle as soon ...

    Engine Power Messages
    ENGINE POWER IS REDUCED This message displays and a chime sounds when the cooling system temperature gets too hot and the engine further enters the engine coolant protection mode. See Engine Overhe ...

    See also:

    Lumbar Adjustment
    To adjust the lumbar support: Press and hold the front or rear of the control to increase or decrease lumbar support. Press and hold the top or bottom of the control to raise or lower the ...

    Deselecting valet mode
    When you enter the vehicle, touch the Valet button to view the Valet mode screen. Enter your 4 digit PIN and touch the OK button. Valet mode deactivated is displayed to indicate that your PIN has ...

    Removal and Installation of the Sealant Canister
    To remove the sealant canister: 1. Unlock the air only hose (F) from the tire sealant canister (B) by pulling up on the lever. 2. Pull the air only hose (F) from the tire sealant canister (B). 3 ...