Buick Enclave: Engine Cover
A. Oil Fill Cap
B. Engine Cover
To remove:
1. Remove the oil fill cap (A).
2. Raise the engine cover (B) to release it from the retainers.
3. Lift and remove the engine cover.
4. Reverse Steps 1 through 3 to reinstall engine cover.
Engine Compartment Overview
A. Radiator Pressure Cap. See Cooling System .
B. Engine Coolant Recovery Cap. See Cooling System .
C. Remote Negative (−) Terminal.
See Jump Starting .
D. Engine Compartment Fuse Block .
...
Engine Oil
To ensure proper engine performance and long life, careful attention must be
paid to engine oil. Following these simple, but important steps will help protect
your investment:
► Always use ...
See also:
Tire Chains
WARNING
Do not use tire chains. There is not enough clearance. Tire chains used on a
vehicle without the proper amount of clearance can cause damage to the brakes, suspension,
or other vehicle pa ...
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate
trim.
2. Turn and pull the license plate lamp forward through the liftgate trim op ...
Attaching the roof carrier
► Secure the roof carrier to roof rails
1.
► Observe the manufacturer's installation
instructions. ...
