Seat belts

The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution. Allow the belts to dry completely before using them. See “Seat belts” in the “1. Safety — s ...

Most common factors contributing to vehicle corrosion

► The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas. ► Damage to paint and other protective coatings caused by gravel and sto ...

See also:

Cargo tie-down rings
Observe the following notes on securing loads: • secure the load using the cargo tie down rings. • do not use elastic straps or nets to secure a load, as these are only intended as an anti ...

Range changing on the move
The recommended method of changing range is with the vehicle stationary. For experienced off-road drivers, a range change on-the-move can be accomplished, as detailed below. ...

Engine block heater (if so equipped)
Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine bloc ...