Mercedes-Benz GL-Class: ATA (Anti-Theft Alarm system)
A visual and audible alarm is triggered if the alarm system is armed and you open:
• a door
• the vehicle with the mechanical key
• the tailgate
• the hood
The alarm is not switched off, even if you close the open door that has triggered it, for example.
If the alarm stays on for more than 30 seconds, the emergency call system mbrace (USA only) or TELE AID (Canada only) initiates a call to the Customer Assistance Center automatically. The emergency call system initiates the call provided that:
• you have subscribed to the mbrace/TELE
AID service.
• the mbrace/TELE AID service has been
activated properly.
• the required mobile phone, power supply
and GPS are available.
► To arm: lock the vehicle with the SmartKey or KEYLESS-GO.
Indicator lamp 1 flashes. The alarm system is armed after approximately 10 seconds.
► To deactivate: unlock the vehicle with the SmartKey or KEYLESS-GO.
X To stop the alarm using the SmartKey:
insert the SmartKey into the ignition lock.
The alarm is switched off.
or
► Press the
button on the
SmartKey.
The alarm is switched off.
► To stop the alarm using KEYLESS-GO:
grasp the outside door handle. The SmartKey must be outside the vehicle.
The alarm is switched off.
or
► Press the Start/Stop button on the
dashboard. The SmartKey must be inside
the vehicle.
The alarm is switched off.
Immobilizer
The immobilizer prevents your vehicle from being started without the correct SmartKey. When leaving the vehicle, always take the SmartKey with you and lock the vehicle. The engine can be started ...Opening/closing
...See also:
3-D Lane Guidance
Some major metropolitan areas may include a 3-D lane guidance feature for highway
exits and junctions. This feature gives you an enhanced representation of the exits
and junctions on the route. ...
Rear Vision Camera (RVC)
The vehicle may have a rear vision camera system. Read this entire section before
using it.
WARNING
The RVC system does not display pedestrians, bicyclists, animals, or any other
object located ...
Overheated Engine Protection Operating Mode
If an overheated engine condition exists and the ENGINE POWER IS REDUCED message
is displayed, an overheat protection mode which alternates firing groups of cylinders
helps prevent engine damage. In ...