Mercedes-Benz GL-Class: Releasing seat belts
► Press release button 4 and guide belt tongue 2 back towards belt sash guide 1.
Make sure that the seat belt is fully rolled
up. Otherwise, the seat belt or belt tongue
will be trapped in the door or in the seat
mechanism. This could damage the door,
the door trim panel and the seat belt.
Damaged seat belts can no longer fulfill their protective function and must be replaced. Consult an authorized Mercedes- Benz Center.
Belt height adjustment
You can adjust the seat belt height on the
driver's seat and the front-passenger seat.
Adjust the height so that the upper part of the
seat belt is routed across the center of your
shoulder.
...
Belt warning for the driver and frontpassenger
Regardless of whether the driver and front
passenger have fastened their seat belts
already, the seat belt warning lamp
lights up for 6 seconds after every engine
start. It then goes out if the d ...
See also:
Sheet Metal Damage
If the vehicle is damaged and requires sheet metal repair or replacement, make
sure the body repair shop applies anti-corrosion material to parts repaired or replaced
to restore corrosion protection ...
Programing
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the end of the original garage door opener hand-held transmitter 2 to
6 inches (50 to 150 mm) away from the transc ...
Windshield Wiper/Washer
The windshield wiper/washer lever is located on the left side of the steering
column.
Turn the band with the wiper symbol to control the windshield wipers.
: Use for a single wiping cycle.
: U ...