Buick Enclave: Antilock Brake System (ABS) Warning Light - Warning Lights, Gauges, and Indicators - Instruments and Controls - Buick Enclave Owner's ManualBuick Enclave: Antilock Brake System (ABS) Warning Light

The ABS warning light comes on briefly when the ignition key is turned to ON/RUN.

The ABS warning light comes on briefly when the ignition key is turned to ON/RUN. This is normal.

If the light does not come on then, have it fixed so it will be ready to warn you if there is a problem.

If the light stays on, turn the ignition to LOCK/OFF. If the light comes on while driving, stop as soon as possible and turn the ignition off.

Then start the engine again to reset the system. If the light still stays on, or comes on again while driving, the vehicle needs service. If the regular brake system warning light is not on, there are still brakes, but no antilock brakes. If the regular brake system warning light is also on, there are no antilock brakes and there is a problem with the regular brakes. See Brake System Warning Light

    Brake System Warning Light
    The vehicle brake system consists of two hydraulic circuits. If one circuit is not working, the remaining circuit can still work to stop the vehicle. For normal braking performance, both circuits n ...

    Tow/Haul Mode Light
    This light comes on when the Tow/Haul mode has been activated. For more information, see Tow/Haul Mode . ...

    See also:

    Call volume
    The phone call volume is operated by the audio system’s volume control. If the audio system is in use when a phone call is active, the audio system source is suppressed for the duration of the ca ...

    Recirculation
    When selected, the air is inside of the screen. recirculated inside the vehicle. This helps to maintain a high or low temperature, and is useful for preventing fumes entering the vehicle. Note: ...

    Brake temperature
    In extreme circumstances, the HDC system may cause brake temperatures to exceed their pre-set limits. If this occurs the warning HDC TEMPORARILY UNAVAILABLE will be displayed in the message center ...