Infiniti QX: Vehicle Dynamic Control (VDC) OFF switch
The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor. If maximum engine power is needed to free a stuck vehicle, turn the VDC system off. To turn off the VDC system, push the VDC OFF switch. The indicator will illuminate. Push the VDC OFF switch again or restart the engine to turn on the system. (See “Vehicle Dynamic Control (VDC) system” in the “5. Starting and driving” section.)
Intelligent Brake Assist (IBA) OFF switch (if so equipped)
The vehicle should be driven with the
Intelligent Brake Assist (IBA) system on
for most driving conditions.
The Intelligent Brake Assist (IBA) system
will sound a warning chime to alert the ...
Clock
If the power supply is disconnected, the
clock will not indicate the correct time.
Readjust the time.
ADJUSTING THE TIME
1. To set the clock forward, push the
button 1 .
2. To set the cloc ...
See also:
Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located under the storage tray on the
driver side trim panel (over the rear wheelhouse).
To access the tire sealant and compressor kit:
1. Remove the tray b ...
Customer Satisfaction Procedure (Mexico)
Did you get the Warranty Extension Plan? This plan is recommended by General
Motors to supplement the warranty included with the new vehicle purchase.
See your dealer for details.
Customer Assist ...
Beltminder (red)
If the vehicle is motion and an occupied front seat’s seat belt is unbuckled,
the seat belt warning lamp will illuminate and a chime will sound.
Note: The speed thresholds and the behavior of t ...
