Infiniti QX: Intelligent Brake Assist (IBA) OFF switch (if so equipped)
The vehicle should be driven with the
Intelligent Brake Assist (IBA) system on
for most driving conditions.
The Intelligent Brake Assist (IBA) system
will sound a warning chime to alert the
driver when the vehicle is traveling too
close to the vehicle ahead and will apply
the brake control if necessary.
To turn off the system, push the IBA OFF
switch. The 
indicator will
illuminate.
The IBA system will remain in the last ON
or OFF state it was left in until it is
manually changed by pushing the IBA OFF
switch.
See “Intelligent Brake Assist (IBA) system”
in the “5. Starting and driving” section.
Tow mode switch
TOW MODE should be used when pulling a
heavy trailer or hauling a heavy load.
Driving the vehicle in TOW MODE with no
trailer/load or light trailer/light load will
not cause any damage. Howe ...
Vehicle Dynamic Control (VDC) OFF switch
The vehicle should be driven with the
Vehicle Dynamic Control (VDC) system on
for most driving conditions.
If the vehicle is stuck in mud or snow, the
VDC system reduces the engine output to ...
See also:
Warning Lights, Gauges, and Indicators
WARNING lights and gauges can signal that something is wrong before it becomes
serious enough to cause an expensive repair or replacement. Paying attention to
the warning lights and gauges could ...
Off-Road Recovery
The vehicle's right wheels can drop off the edge of a road onto the shoulder
while driving.
Follow these tips:
1. Ease off the accelerator and then, if there is nothing in the way, steer the ...
Important safety notes
WARNING
When operating the climate control, the air
that enters the passenger compartment
through the air vents can be very hot or very
cold (depending on the set temperature). This
c ...
