Buick Enclave: Turn and Lane-Change Signals
An arrow on the instrument panel cluster flashes in the direction of the turn or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is completed. If the lever is briefly pressed and released, the turn signal flashes three times.
The lever returns to its starting position whenever it is released.
If after signaling a turn or lane change the arrow flashes rapidly or does not come on, a signal bulb might be burned out.
Have the bulbs replaced. If the bulb is not burned out, check the fuse.
See Fuses and Circuit Breakers .
Hazard Warning Flashers
Hazard Warning Flasher:
Press this button located on the instrument panel below the audio system, to
make the front and rear turn signal lamps flash on and off.
This warns others that you are h ...
Turn Signal On Chime
If either one of the turn signals is left on and the vehicle has been driven
more than 1.2 km (0.75 mi), a chime will sound. ...
See also:
Passenger Sensing System
If the vehicle has the passenger airbag status indicator pictured in the following
illustration, then the vehicle has a passenger sensing system for the right front
passenger position. The passenger ...
Doing Your Own Service Work
If the vehicle is a hybrid, see the hybrid supplement for more information.
WARNING
It can be dangerous to work on your vehicle if you do not have the proper knowledge,
service manual, tools, o ...
Reading Lamps
For vehicles with reading lamps in the overhead console, press the button located
next to the lamp to turn it on or off.
The vehicle may also have reading lamps in other locations. The lamps cannot
...
