Range Rover: Stability control - Range Rover Owner's ManualRange Rover: Stability control

Changing from low to high range
With the vehicle traveling no faster than 38 mph (60 km/h), select N. Press the front of the transfer gearbox switch to select Hi. Indication of the range change status is the same as for the stati ...

Stability control warning lamps
The DSC warning lamp in the instrument pack illuminates briefly when the ignition is turned on. If the warning lamp flashes rapidly during driving, the system is active. A fault with the DSC sys ...

See also:

Fuel System Messages
FUEL LEVEL LOW This message displays and a chime sounds if the fuel level is low. Refuel as soon as possible. See Fuel Gauge   and Fuel   for more information. TIGHTEN GAS CAP ...

Tow/Haul Mode
(Tow/Haul): The vehicle may have a Tow/Haul mode. The button is located on the instrument panel under the climate controls. Push the button to activate the system. Push it again to deactivate the ...

Entry gate/canadian programing
The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programing. Continue to press and hold the desired rear-view ...