Cadillac Escalade: Settings for Parental Control - Rear Seat Entertainment (RSE) System (Headrest DVD) - Rear Seat Infotainment - Infotainment System - Cadillac Escalade Owner's ManualCadillac Escalade: Settings for Parental Control

Use the SETUP MENU to access the parental control feature. It allows for control of the type of movie rating content (from G to Adult) that can be viewed and is only accessible when no disc is loaded.

To setup the Parental Control:

1. Press the SETUP button on the remote control.

2. Use the left/right and down navigation arrows on the remote control to select the Parental sub-menu under the Preference Page.

3. Press the SETUP button, and use the right and up/down navigation arrows to select any one of the available Rating settings from the display menu. The Rating settings are:

. Kid SAF
. G
. PG 13
. PG R
. R
. NC 17
. ADULT

4. Press the ENTER button to confirm the selection.

If a disc is inserted into the DVD compartment slot and it exceeds the Parental

If a disc is inserted into the DVD compartment slot and it exceeds the Parental Setting, the following message appears on display:

The Parental Setting of this player prohibits play. Would you like to allow this disc to play?

If yes if selected, the six digit password must be entered for the disc to play. If the wrong password is entered, the following message appears:

This movie will not play due to the Parental Setting of the player.

To create a six digit password, use the numeric keypad on the remote control. Press the ENTER button to confirm. The default password is 136900.

To change the Parental Control Password:

1. Press the SETUP button on the remote control

2. Navigate to the Password sub-menu under the Password Setup Page.

2. Navigate to the Password sub-menu under the Password Setup Page.

3. Press the right navigation arrow, then press ENTER.

4. At the Old Password option, enter the old password or the default password

4. At the Old Password option, enter the old password or the default password (136900).

5. At the New Password option, enter the new password (six digits) using numeric buttons.

6. At the Confirm PWD option, confirm the new password by entering the new password again.

7. Scroll to the OK button and press ENTER. The message “Your password has been changed” displays.

    Using the Base RSE On-Screen Display (OSD) Menus
    Use the OSD setup display menus for: Initial setup Display setup Parental control setup Adjusting the picture quality Setting the various outputs On-screen display language To use the ...

    Rear Seat Audio (RSA) System
    The loading slot for the DVD player is located at the top of the head restraint. Insert the disc partially into the loading slot with the printed side facing the rear of the vehicle. The DVD player ...

    See also:

    Folding the exterior mirrors in or outautomatically
    If the "Fold in mirrors when locking" function is activated in the on-board computer: • the exterior mirrors fold in automatically as soon as you lock the vehicle from the outside. ...

    Washer Fluid
    What to Use When adding windshield washer fluid, be sure to read the manufacturer's instructions before use. If the vehicle will be operating in an area where the temperature may fall below f ...

    Running out of fuel
    Avoid running out of fuel. Doing so can cause damage to the vehicle's engine, fuel, and emission control systems. If the vehicle does run out of fuel, a minimum of 1.1 U.S. gallons (4 liters) ...