Infiniti QX: Meter/ring illumination and needle sweep - Meters and gauges - Instruments and controls - Infiniti QX Owner's ManualInfiniti QX: Meter/ring illumination and needle sweep

The ring illumination surrounding meters and gauges illuminates when the driver’s door is closed after getting into the vehicle with the Intelligent Key carried in. When the engine is started, the indicator needles will sweep in the speedometer and tachometer and the ring illumination will be brightened gradually. This function can be turned off. (See “Trip computer” later in this section.)

    Voltmeter
    When the ignition switch is pushed to the ON position, the volt meter indicates the battery voltage. When the engine is running, it indicates the generator voltage. While cranking the engine ...

    See also:

    Liftgate
    Manual Liftgate Operation WARNING Exhaust gases can enter the vehicle if it is driven with the liftgate or trunk/hatch open, or with any objects that pass through the seal between the body and the ...

    Lane Departure Warning (LDW) system
    Precautions on LDW system WARNING ► This system is only a warning device to inform the driver of a potential unintended lane departure. It will not steer the vehicle or prevent loss of ...

    License Plate Lamp
    To replace one of these bulbs: 1. Remove the two screws holding each of the license plate lamps to the liftgate trim. 2. Turn and pull the license plate lamp forward through the liftgate trim op ...